- 2012-06-18 12:50:08
How to Repair a Paper Cutter
Put on the work gloves. Put the paper cutter on a table with the blade facing up.
Pick up the cutting arm. Hold the cutting arm with the groove on the bottom facing down.
Micro Bore Sizing
Machines for processing small bores from 0.015 mm to 4 mm
Place the groove of the cutting arm over the cutting blade on the paper cutter. Line up the ends of the cutting arm with the ends of the cutting blade.
Push down on the cutting arm. Continue pushing until the top of the cutting blade has gone completely into the groove at the bottom of the cutting arm.
Tape the sides of the cutting arm to both sides of the cutting blade with cellophane tape.
Tape the top end of the cutting arm that is butted against the cutting assembly at the top of the paper cutter with duct tape.
Apply another piece of duct tape to the top end of the cutting arm where it is butted against the cutting assembly. Smooth the duct tape down with your fingers.
Bring the cutting blade completely down on the paper cutter. Attach the side latch to the nub on the side of the cutting blade. Return the paper cutter to its original location.
- Previous [Return Home] [Print] [Go Back]